Rod probe SAT

With synthetic thread

With up to 7 probe systems, Fluid Temperature: -40°C … 150°C

  • Simple installation and setup
  • Up to 6 measuring points
  • ATEX-approval

 

Categories: , ,

Description

The SAT rod probes are used in conjunction with the evaluation units (eg, SRA-100-U0) is used for level detection and level control in conductive liquids.
Depending on the number of bars and evaluation devices used, different measurement tasks such as Overflow, dry run, two-step control, moisture detection, etc. are realized.
Depending on model selected can include the container wall as a mass, to be implemented to 7 switch points. The ground connection erflogt either directly to the container or conducting a probe rod.
In the probe head, an additional module (diode module LBM) for permanent circuit monitoring to be installed.

In the case of a line break between the electrode probe and an appropriate evaluation, the evaluation issue an alert.

Ex_Zulassung Prozesstemperatur_150 Druck_bis_10 Keine_bewegten_Teile Messpunkte_bis_7 Korresionsbestaendig
Process pressure max. -1bar … +10bar
Process temperature -40°C…+150°C
Protection class IP65 EN/IEC 60529
Material Process connection POM
PP
PTFE
Material Electrode rod Steel 1.4404 (AISI316L)
Steel 1.4571 (AISI316TI)
Hastelloy C22
Isolation Electrode rod isolation PA
ETFE
E-CTFE
Gaskets
(medium contact)
NBR (Electrode isolation PA)
FPM (Electrode isolation ETFE/E-CTFE)

Documentation german

User manual
Datasheet

Documentation english

User manual
Datasheet

Product configurator